
Bulletin 2097 Memory Module Programmer 5
Publication 2097-QS001D-EN-P - November 2011
Operation with External Power Supply
You can operate the memory module programmer with a customer-supplied external power
supply. Refer to Specifications
on page 15 for power supply requirements.
To use the memory module programmer with your external power supply, the power supply
requires an extra-low voltage plug with the following dimensions.
ATTENTION: The memory module programmer contains electrostatic discharge (ESD) sensitive
parts and assemblies. You are required to follow static-control precautions when you use it. If you
do not follow ESD control procedures, components can be damaged. If you are not familiar with
static control procedures, refer to Guarding Against Electrostatic Damage, publication 8000-4.5.2
,
or any other applicable ESD awareness handbook.
You can remedy occasional memory module programmer anomalies by turning it off and on.
+6V DC
–
9.5
(0.37)
5.5
(0.22)
2.1
(0.08)
Dimensions are in mm (in.).
CAT. NO. 2097-PGMR
For detailed information
refer to instruction
manual
HW/SW REV:1A 10
SN: 2097-PGMR012345678
6V DC 150 mA min
Power Supply
(FRIWO 7207/06 1.0791 MPP15)
External Power Supply Connector
Komentáře k této Příručce