Rockwell-automation 1790D-XXXX DeviceNet Digital Base Terminal Block C Uživatelský manuál stáhnout pdf (Strana 15)

DeviceNet Digital Base Terminal Block CompactBlock LDX I/O 15

Publication

1790-IN006C-EN-P - May 2006

Connect the DeviceNet Cable

Follow these procedures to connect the DeviceNet cable to the base

block. We do not supply the DeviceNet connector with the base

block. You must purchase the connector separately. These are the

types of connectors you order directly from Rockwell Automation.

• 1799-DNETCON - 5-position open-style connector

• 1799-DNETSCON - 5-position open-style connector with

locking screws

• 1799-DNC5MMS - 5-position open-style to 12 mm connector

with locking screws

1. Connect the DeviceNet wiring (drop line) to one of the

DeviceNet connectors as shown in the figure, noting that a

color-coded wiring diagram is printed next to the connector

on the left side of the base block.

WARNING

If you connect or disconnect the DeviceNet cable with power applied

to this module or any device on the network, an electrical arc can

occur. This could cause an explosion in hazardous location

installations.

Be sure that power is removed or the area is nonhazardous before

proceeding.

Wiring Diagram for

1799-DNETCON

Wiring Diagram for

1799-DNC5MMS Connecto

r

Drain/Shield

Can_H White

Can_L Blue

V+ Red

V- Black

V- Black

Can_L Blue

Drain/Shield

Can_H White

V+ Red

Connector

44186

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Komentáře k této Příručce

Žádné komentáře