Rockwell-automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Devic Uživatelský manuál stáhnout pdf (Strana 13)

Rockwell Automation Publication 1788-UM059A-EN-P - August 2014 13

Install the Linking Device Chapter 2

Set the Linking Device IP Address by Using DHCP/BOOTP

When DHCP/BOOTP is enabled and a DHCP or BOOTP server is found, the

IP address, subnet mask, and gateway address are automatically configured by the

DHCP server, as shown in the following figure.

Automatic Configuration

Launch a DHCP/BOOTP Server. If using the Rockwell Automation DHCP/

BOOTP server, then follow these steps to change the IP address, Subnet mask,

and Gateway address from this dialog box.

1. Click New.

The Properties dialog box appears.

2. Enter the appropriate values into the following boxes.

• Ethernet address (MAC ID) from the linking device product ID label

• IP address

• Subnet Mask

• Gateway (IP address)

3. Click OK.

TIP

The use of DHCP is the default configuration for the linking device as shipped.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Žádné komentáře

Rockwell-automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Devic Uživatelský manuál Strana 13