Rockwell-automation 1769-SM2 Compact I/O DSI/Modbus Network Communicat Uživatelský manuál stáhnout pdf

Installation Instructions

1769-SM2 Compact I/O DSI/Modbus

Network Communication Module

This document instructs how to install a 1769-SM2 Compact I/O DSI/Modbus

Network Communication Module into the controller.

Related Documentation

Documentation can be obtained online at www.rockwellautomation.com/literature.

To order paper copies of technical documentation, contact your local Rockwell

Automation distributor or sales representative.

For information such as firmware updates and answers to drive-related questions, go

to the Drives Service & Support web site at www.ab.com/support/abdrives

and click

on the “Downloads” or “Knowledgebase” link.

ATTENTION: Risk of equipment damage exists. Remove power before

installing or removing the 1769-SM2 module. When you install or remove

the module with power applied, an electrical arc may occur. An electrical

arc can cause personal injury or equipment damage by:

• Sending an erroneous signal to your system’s field devices, causing

unintended machine motion.

• Causing an explosion in a hazardous environment.

Electrical arcing causes excessive wear to contacts on both the module

and its mating connector. Worn contacts may create electrical resistance.

ATTENTION: Risk of equipment damage exists. The 1769-SM2

module contains ESD (Electrostatic Discharge) sensitive parts that can be

damaged if you do not follow ESD control procedures. Static control

precautions are required when handling the module. If you are unfamiliar

with static control procedures, refer to Guarding Against Electrostatic

Damage, publication 8000-4.5.2.

Document Description

1769-SM2 Compact I/O DSI/Modbus

Network Communication Module User

Manual, publication 1769-UM013

Provides complete installation, wiring, setup, and

communication information for the 1769-SM2 Network

Communication Module.

Guarding Against Electrostatic Damage,

publication 8000-4.5.2

Provides static control procedures for protecting

electrostatic discharge sensitive parts.

Wiring and Grounding Guidelines for PWM

AC Drives, publication DRIVES-IN001

Guidelines for proper wiring, grounding, and shielding, and

standard practices for noise protection.

Step 1

Remove power from the controller.

1 2 3 4 5 6 7 8

Installation Instructions 1

Shrnutí obsahu

Strany 1 - Installation Instructions

Installation Instructions1769-SM2 Compact I/O DSI/ModbusNetwork Communication Module This document instructs how to install a 1769-SM2 Compact I/O D

Strany 2

2 Step 2Set the 1769-SM2 module Configuration Mode switch and Operating Mode (Single/Multi-Drive) switch to appropriate positions. For complete swi

Strany 3

3 Step 4Mount the 1769-SM2 module.Maintain spacing from enclosure walls, wireways, adjacent equipment, etc. Allow 50 mm (2 in.) of space on all sid

Strany 4

4 Figure 2 1769-SM2 Module with CompactLogix Controller Figure 3 1769-SM2 Module with Remote 1769-Based Adapter Using Module as a TemplateThe

Strany 5

5 e. Place the modules back on the panel, and check for proper hole alignment.f. Attach the modules to the panel using the mounting screws.B. DIN

Strany 6

6 F. Before installing the replacement 1769-SM2 module, be sure that the bus lever on the right-side adjacent module is in the unlocked (fully ri

Strany 7

7 Step 8Apply power.A. Apply power to the controller. The status indicators can be viewed on the front of the 1769-SM2 module after power has been

Strany 8

Notes:www.rockwellautomation.comAmericas: Rockwell Automation, 1201 South Second Street, Milwaukee, WI 53204-2496 USA, Tel: (1) 414.382.2000, Fax: (

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 1769-SM2 Compact I/O DSI/Modbus Network Communicat Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Zařízení Rockwell-automation 1769-SM2 Compact I/O DSI/Modbus Network Communicat. Rockwell Automation 1769-SM2 Compact I/O DSI/Modbus Network Communication Module User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 1769-SM2 Compact I/O DSI/Modbus Network Communicat