Rockwell-automation 1751 SynchLink Base Block Installation Instruction Uživatelský manuál stáhnout pdf (Strana 4)

4 SynchLink Base Block

Publication 1751-IN001A-EN-P - March 2001

Prevent Electrostatic Discharge

Installing the Base Block

To install the base block on the DIN rail:

1. Position the base block on the 35×7.5mm DIN rail (Allen-Bradley catalog

number 199-DR1) at a 30° angle.

ATTENTION

Electrostatic discharge can damage integrated circuits or

semiconductors if you touch backplane connector pins.

Follow these guidelines when you handle the base block:

• Touch a grounded object to discharge static potential.

• Wear an approved wrist-strap grounding device.

• Do not touch the backplane connector or connector pins.

• Do not touch circuit components inside the base block.

• If available, use a static-safe work station.

• When not in use, keep the base block in its static-shield

box.

31203a-M

1 2 3 4 5 6 7 8 9 ... 15 16

Žádné komentáře

Rockwell-automation 1751 SynchLink Base Block Installation Instruction Uživatelský manuál Strana 4