Rockwell-automation 1747-DU501 SLC 5/05 Processors Firmware/Operating Uživatelský manuál stáhnout pdf (Strana 16)

16 SLC 5/05 Processors Firmware/Operating System ControlFLASH Upgrade

Publication 1747-IN019G-EN-P - December 2011

After Successfully Updating Your SLC 5/05 Processor

1. Remove power from the SLC 500 power supply and remove the processor from the chassis.

2. Apply the enclosed operating system upgrade label to the SLC 5/05 processor nameplate.

3. Re-insert the processor into the chassis and apply power.

4. Restore your program to the processor.

ControlFLASH Error Messages

There are three error messages you can receive.

•Invalid Catalog Number

• Target Module Not in Proper State for Programming

• Failed to Receive Initial TFTP Request from Target

Invalid Catalog Number

The following error message is displayed if:

• the ControlFLASH tool is unable to match the processor to the catalog number that was selected in

the catalog Number dialog box, or

• the tool is unable to identify the processor type selected because the J4 jumper is in the Program

position.

To clear this error:

1. Click OK.

2. Click Cancel to go to the Catalog Number dialog box. You may either:

• select the correct catalog number in the dialog box, and proceed with the update, or

ATTENTION: Do not remove the processor from the SLC 500 chassis until all

power is removed from the SLC 500 power supply.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

Rockwell-automation 1747-DU501 SLC 5/05 Processors Firmware/Operating Uživatelský manuál Strana 16