Rockwell-automation 1746-NO8V SLC 500 8-Point Analog Output Module/ Us Uživatelský manuál Strana 20

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 74
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 19
Publication 1746-UM026A-EN-P - September 2003
2-12 Installation and Wiring
A system may malfunction due to a change in its operating
environment. After installing and wiring your module, check system
operation. See your controller’s User Manual for more information.
Labeling and Re-Installing
the Terminal Block (if it is
removed)
The supplied terminal cover has a write-on label. Using this label
helps ensure that the terminal block is installed on the correct module.
Once you have wired your module and properly labeled the terminal
cover, install the terminal block on your module:
1. Align the terminal block with the receptacle.
2. Insert the terminal block and press firmly at the top and bottom
until it is properly seated.
3. Screw in the two retaining screws on the top and bottom of the
terminal block. Maximum torque is 0.7 to 0.9 Nm (6 to 8 in-lbs.).
Zobrazit stránku 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 73 74

Komentáře k této Příručce

Žádné komentáře