Rockwell-automation 1441-DYN25-Z Dynamix 2500 Data Collector Uživatelský manuál stáhnout pdf (Strana 135)

Rockwell Automation Publication 1441-UM001B-EN-P - September 2012 135

Collecting and Reviewing Data Chapter 5

Start Data Collection

After setting the data collector options and selecting a route, you are now ready to

start data collection.

Follow these steps to start collecting data.

1. Once you have selected a list, you begin collecting data from the designated

point on the route.

2. Connect the transducer and press Enter to start a measurement.

3. If necessary, press Enter again to collect a measurement depending on the

Auto Store setting in the Instrument Configuration screen.

See Instrument Configuration Parameters on page 59

You may notice that a Bias Check is taken if the parameter is set to Auto.

IMPORTANT

The Dynamix 2500 data collector supplies power to ICP

accelerometers through the A and B connectors. The ICP power `turns

on’ prior to collecting the first measurement point and remains on

until the following occurs:

• You reach the end of the route.

• The data collector advances to a measurement point that does not

require ICP power.

• You exit the route menu.

Do not connect the channel to a BNC panel or non ICP device until the

Dynamix 2500 data collector advances to a non ICP measurement

point. Connecting the channel while collecting a measurement point

that requires ICP power may cause undesirable results, damage to the

equipment, or unexpected machinery trips.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 217 218

Žádné komentáře

Rockwell-automation 1441-DYN25-Z Dynamix 2500 Data Collector Uživatelský manuál Strana 135