Rockwell-automation 1440-TBS-J XM Dynamic Measurement Module Terminal Uživatelský manuál stáhnout pdf (Strana 12)

12 XM Dynamic Measurement Module Terminal Base

Publication

ICM-IN003D-EN-P - March 2013

Install the Terminal Base

The terminal base can be DIN rail or wall/panel mounted.

Mount on a DIN Rail

Follow these steps to mount the terminal base on the DIN rail.

1. Position the terminal base unit on the 35 x 7.5 mm DIN rail (A) (A-B

pt no. 199-DR1 or 199-DR4) at a slight angle.

WARNING

If you insert or remove the module while backplane power is on, an electrical

arc can occur. This could cause an explosion in hazardous location

installations.

Be sure that power is removed or the area is nonhazardous before proceeding.

ATTENTION

Do not remove or replace a terminal base unit while power is applied.

Interruption of the backplane can result in unintentional operation or machine

motion.

31887-M

Position terminal base at a slight angle and hook over the top of the DIN rail.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Žádné komentáře

Rockwell-automation 1440-TBS-J XM Dynamic Measurement Module Terminal Uživatelský manuál Strana 12