Rockwell-automation 1203-EN1 EtherNet/IP-to-SCANport Module Uživatelský manuál Strana 14

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 186
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 13
1-2 Getting Started
The EtherNet/IP-to-SCANport module features the following:
The module is an external module only. It requires DC power from
either an appropriate DC power source or AC-to-DC converter.
Connectors for both are provided.
A number of configuration tools can be used to configure the module
and connected drive. These include drive-configuration software tools
such as DriveExplorer (version 4.03 or higher) or DriveExecutive
(version 3.01 or higher). In addition, you can use a BOOTP server to
configure some of the network features on the module (for example,
the IP address).
Status indicators report the status of the drive, module, and network.
I/O, including Logic Command/Reference and up to four pairs of
Datalinks, may be configured for your application using parameters.
Explicit messages (parameter read/write, etc.) are supported.
Master-Slave and/or Peer-to-Peer hierarchies can be set up so that the
module and connected SCANport drive transmit data to and from a
scanner and/or another SCANport drive on the network.
User-defined fault actions determine how the module and SCANport
drive respond to communication disruptions on the network.
Each module has Web pages that display information about the
module and the connected drive.
The module can be configured to send e-mail messages to desired
addresses when selected drive faults occur and/or are cleared, and/or
when the module takes a communication or idle fault action.
Features
Zobrazit stránku 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 185 186

Komentáře k této Příručce

Žádné komentáře